OPTO Squad

Revised Burst Lengths and Gap Times for IR Receiver Modules for Remote Control Systems

Corrected datasheets are now available for the TSOP11…, TSOP12…, TSOP13…, TSOP14… and TSOP18… Series IR receiver modules. Updates include revised burst lengths and gap times as per the following table:

Device Was Is
AGC2 Min. burst length 16 cycles 19 cycles
AGC2 Min. gap time 18 cycles 19 cycles
AGC6 Min. burst length 16 cycles 19 cycles
AGC6 Min. gap time 18 cycles 19 cycles

Corrected datasheets are now available from the following links on www.vishay.com:

TSOP11…
TSOP12…
TSOP13…
TSOP14…
TSOP18…

The IR receiver products did not change. The corrections in the datasheets pertain to timing parameters on page 5 or page 6 of the datasheet. The timing parameters relate to the compatibility of the receivers to data format timing. These were previously incorrectly stated.

Contact Information:

If you have questions, please don’t hesitate to reach out to any of the following Vishay contacts:

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Information

This entry was posted on March 21, 2019 by in Articles.

Follow Blog via Email

Enter your email address to follow this blog and receive notifications of new posts by email.

%d bloggers like this: